New Features
- New configuration file parameters MINSPDS, SPDMANUF and SPDPARTNO to specify the values that the RAM SPD must match before allowing the tests to start. This may be useful for RAM manufacturers that need to verify that the SPD data has been programmed correctly.
- New configuration file parameter SKIPSPLASH to skip the 10 second splashscreen and proceed directly to the main menu
- New mode for the configuration file parameter AUTOMODE to specify that MemTest86 shall run the tests immediately (skipping the splashscreen and main menu) but prompt the user to save the results after test completion
- New configuration file parameters ADDR2SLBITS and ADDR2CSBITS to specify the bit positions of a memory address to exclusive-or (XOR) to determine which DIMM slot/chip select (0 or 1) corresponds to the failure address
Fixes/Enhancements
- Added ECC detection support for Broadwell-H chipset
- Added ECC detection support for Broadwell-DE chipset
- Added ECC detection support for AMD Bald Eagle (2nd generation Embedded R-series)
- Added ECC injection support for AMD Steppe Eagle/Bald Eagle
- Added SMBus (SPD) support for Broadwell-DE
- Fixed decoding of JEDEC manufacture names from the SPD
- DDR3 XMP rev1.3 SPD decoding is now supported
- Fixed retrieval of DDR4 SPD bytes for Intel ICH SMBUS
- Added workaround for buggy firmware when calls to EFI MPServices fail
- Fixed MemTest86 freezing on network boot
- Fixed bug with wrong details being displayed for detected memory warnings in the report file
- Fixed bug with CPU type detection for older CPUs
- Fixed benchmark chart not being displayed after running a RAM benchmark test when there is a failure in saving results to disk
- Report file now includes the RAM serial number, if available
- Various system info related updates/fixes (CPU)
|
|
